|
|
Download BookCourier Firmware
Follow these instructions to download and install the latest BookCourier
software:
- Connect BookCourier to your PC via the USB cable. Also, make sure that you
still have an active Internet connection.
- Before you begin, make sure you already have the latest version of the
Transfer Tool installed. From the Help menu, select the About BookCourier...
option. Compare the Transfer Tool version number to the latest version
number described on the Current Release page in the Support section of the
web site. If you do not have the
latest version of the Transfer Tool, you must download and execute
Setup.exe.
- From the Help menu in the Transfer Tool,
select the Check for Updates option. The Transfer Tool will tell you there
is a newer version of the BookCourier software on the web site and ask you to
confirm your intention to perform the update.
- Press Enter or click the Yes button to start the update. After the file
transfer is complete, a detailed message appears. When you finish reading
the message, press Enter or click the OK button to close the message box.
- Disconnect BookCourier from the PC to complete the software installation.
You will hear a number of messages on BookCourier while the installation
continues. Make sure you do not
remove the memory card or the batteries during this process. Also, be aware that you will lose
any custom settings such as volume level and reading speed. The update
process does NOT affect bookmarks or the file/folder structure. When the
installation is finished, BookCourier will beep and go to sleep. At that
point, you can start using BookCourier again.
|